Cord Drawn Curtain Tracks Instructions

Remove the curtain rod from the.

Cord drawn curtain tracks instructions.

Curtain track features and how to install. Draw the cord until the right hand carrier 1 is as far to the right as possible. Measure the rod s length while it is still on the wall. Remove the curtains from the traverse rods so you can access the cording.

2 pull track apart at the centre. Measure also the distance from the floor to the top of the curtain rod. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. Holding the cords taut push carrier 2 as far to the left as possible.

I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. Click here for how to mend it. Place pulley 2 onto track section and secure with screws. If you re removing an old cord you can untie it.

How to thread cord on curtain rails. Hook cord over the lug on carrier 2 to secure it. Replace sliders at each end. How to fit new cord to curtain tracks take measurements.

Once you have worked out were your track is going to go. Installing your styletrack curtain track. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket.

Most curtain tracks do not have the mounting holes pre drilled. Standard drill bits work fine on all aluminum tracks. To drill holes identify where the holes should be positioned and mark the track. Re attach track onto brackets and re hang curtains.

Then feed cord around and over the top pulley g pass cord back through ovelrap master slide. Add those two. Using a small bit drill pilot holes centered in the slot through the top of the track. Next place the rod face down on a flat surface.

3 unhook cord from master carrier and allow to drop inside track. Cord on overlap master carrier as original. Then remove master carrier from the track.